If FCW/ACC Limited Functionality Service Required pop-up on EVIC and there are no stored or active DTC codes other than Active U148D (Implausible Data Received from Forward Facing Camera) then only replace the forward facing camera module. The forward facing camera module is the camera mounted near the top of the windshield and behind the rear-view mirror. If you have the active fault code of ACC Sensor Adjustment required, please verify that the ACC Module is fully seated in the clips and there is no damage to the module. The ACC Module is the unit looking through the front fascia and located just a bit lower than the bumper. Perform service drive alignment. During alignment record vertical and horizontal misalignment angles (they will show up on screen). These angles will be used for engineering diagnosis. If you are replacing this due to ABS Disabled ECU, please verify that if the brake controller was serviced that a static initialization was run on the brake controller and that all faults were cleared in both the brake controller and ACC Module. Remember to turn vehicle engine off and on after correcting the issue and then clear faults in order to clear active faults. If the above recommendations and the service manual do not resolve the issue or if you are replacing this part for any other reason, please contact the following person based on vehicle model. Eliseo Miranda - cell: (248) 408-6023 - KL, LA, LD, LX, LC, UF Bipinkumar Radadiya: (248) 512-2324 - WK, WD, RU, RU PHEV, WK SRT, M6 Jeremy Whitehead: (248) 904-5490 - M1, M4, MP If you do not receive a call back within 15 minutes please complete the repair, and document all available information for a follow-up call. ______________________________________ Contact Us at CAGRIS@Chrysler.com for feedback related ONLY to this GPOP Tech Tip. DO NOT email regarding repair procedures unrelated to this Tech Tip or part order inquires. Please include the Part Number (s) and Tech Tip Part Description of the Tech Tip you are referencing for our tracking system. |